CNC machining summary

1. When the CNC machine is first turned on, it is necessary to revert to the original point of the three axes and check whether the guide oil and spindle hydraulic oil of the machine are sufficient. If it is not enough, we should refuel in time.

2. The size of the cnc machining product should correspond well with the drawing, and the first inspection and inspection should be done, and the error should be corrected in time.

3. In the cnc machining, after the program is interrupted, it is easy to make mistakes when modifying the program, so we need to check carefully.

4. When you need to change the tool in the cnc machining processing, you need to zero the XYZ axis. If the depth of processing is not affected after the tool change, then the tool will be directly shaken to the XYZ axis with the hand wheel after processing. If the depth of machining may be affected after the tool change, the tool depth should be readjusted. This step is still complicated for beginners, but it is a necessary skill to master in machining.

5. We must adjust the tool before each program run. Forgetting to adjust the tool is a dangerous operation, the lighter the disability, the heavier the death, machine destruction. Therefore, we have to remember to adjust the tool as a step operation.

6. Many times we will have the workpiece scrapped because the number in the G60 is not zeroed. When we use the G60 in the machining, we should change it in time after using it. If the latter operation did not go to see in time, then the workpiece made later will be a defective product.